Hybrid Heat Pump
This choice is sometimes referred to as a Dual Fuel Heat Pump. It utilized both gas and electricity to heat your home. The efficiency of a heat pump is because at most heating temperatures, it moves heat from outside to inside.
Think about your refrigerator. When the inside warms up to 40•, the food risks going bad, so the fridge finds the heat and pumps in out. Your food stays refrigerated. At 40• outside, a heat pump can find heat and efficiently bring it inside. This costs less than consuming natural gas, propane or electricity to produce heat in a furnace.
At much lower temperatures, a heat pump will need a boost to maintain the heat. This is an electric resistance strip heater. It is used in emergency and back up situations.
A hybrid heat pump uses a conventional furnace for emergency and back up. This is less expensive than electric resistance heat.
In our climate zone; I believe the rank of these approaches should be:
- Hybrid Heat Pump
- Traditional Furnace / AC
- Air Source Heat Pump
This ranking is based primarily on Efficiency Issues with overall comfort issues second. This rank considers only long term operating costs. It does not consider capital costs (installation).
There are two primary considerations for all of the installation and ultimately comfort issues.
- The home must be ready for an efficient heating/ac equipment installation. This means the thermal envelope must be sealed and well insulated. Your thermal envelope is defined as the basement walls, or crawl space walls, the wall above ground, the ceiling.
- The calculations for equipment size, and selection must be done professionally. The use of a recognized computer program authorized by the ACCA (Air Conditioning Contractors of America); showing the Manual J calculations of the improved home for determining heat loads; and the Manual S calculations to select the equipment. You may wish to have your ductwork reviewed and perhaps resized. This would call for calculations with ACCA Manual D.
The choice to go with Geothermal or ASHP would mean very little gas usage, only the hot water heater. That could be converted to electric with the ASHP. With a Geothermal Unit, you could utilize a system of hot water that is known as ‘de-superheating’. It uses otherwise wasted heat from the Heat Pump unit to heat water.
The capital costs of these units in the Wichita area are estimated at:
- Geothermal: 15-25,000 (open or closed loop)
- ASHP: 7 -10,000
- Hybrid Heat Pump: 7 – 10,000
- Furnace/AC 7 -10,000
The Geothermal unit is considered to be a renewable energy source and carries a 30% tax credit, with no limit. It is available through 2016.
Comfort Note: Conventional Furnaces blow heated air into the duct work at temperatures from 105 – 150; depending and the design factors of the furnace. If you have come in from the cold and stood neat the supply register of a forced air furnace, you feel the heat. A heat pump type of heating does not create heat to be blown into the duct work at these high temperatures, a heat pump typically blows air into the ducts at 85 – 105 degrees. This change can cause people to not like a heat pump; air source or ground source. A hybrid heat pump would provide the same range as a furnace with lower outside temperatures.
Please post your questions below as comments!